2008 Mercury Mariner Rear Bumper Cover / Fascia Removal and Replacement
download BUMPER COVER – REAR Exploded View Removal and Installation 1. Remove the 2 rear bumper cover lower screws (1 each side). To install, tighten to 5 Nm (44 lb-in) . 2. Remove the 4 rear bumper...
View Article2005–2006 Toyota Tacoma CLUTCH PEDAL SQUEAK NOISE
download Some customers may complain about a “squeak” or “creak” noise when depressing or releasing the clutch pedal. The clutch master cylinder clevis assembly has been improved to eliminate this...
View Article2000 Ford F-150 Temperature Blend Door Actuator REMOVAL AND INSTALLATION
download Temperature Blend Door Actuator Removal All vehicles 1. Depower the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and...
View Article2007 Honda Element Front Bumper Removal/Installation
download Front Bumper Removal/Installation NOTE: Have an assistant help you when removing and installing the front bumper. Take care not to scratch the front bumper and body. Put on gloves to protect...
View Article1999 Chevrolet Chevy Suburban Transfer Case Internal Components Assemble
download 1. 2. 3. 4. 5. Install the spring retainers to the synchronizer hub. Align the scribe marks previously made on the synchronizer hub and the synchronizer sleeve. Install the synchronizer hub to...
View Article2002 Ford escape Transaxle INSTALLATION
download 1. If installing a new or remanufactured transaxle, install the roll restrictor bracket. 2. Install the special tool. 3. Position the transaxle in place. 4. Remove the special tool. 5. Move...
View Article2003 Mazda 6 FRONT BUMPER REMOVAL/INSTALLATION
download 1. Disconnect the negative battery cable. 2. Disconnect the front side maker light connector. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Front...
View Article1996 Ford Mustang Bumper and Bumper Cover Front Removal and Installation
download 1. Drill out four license plate rivets (if required). 2. Remove fog lamps (15200) (if equipped). 3. Remove two nuts and two screws retaining front bumper (17757) to each front fender (16005)....
View ArticleTOYOTA FJ CRUISER – FRONT BUMPER INSTALLATION INSTRUCTIONS
download Front Bumper Installation – TOYOTA FJ CRUISER Step 1 Very Important Before beginning installation, assure that vehicle has been pulled forward into work-area with the wheels straight and that...
View Article1986 Chevy Truck C 10 P/U Steering Column: Service and Repair Assembly
download 1. To assemble bearing housing, proceed as follows: a. Using a suitable socket, press bearings into bearing housing. b. Install lock shoe springs, lock shoes and shoe pin into bearing housing....
View Article2008 Honda Civic Rear Bumper Removal/Installation
download NOTE: Have an assistant help you when removing and installing the rear bumper. Take care not to scratch the rear bumper and body. Put on gloves to protect your hands. 1. Remove the clips (A),...
View Article
